I started messing around with the breather tube. I positioned the 5/8" ID rubber hose on the breather fitting...
...routed it down the firewall, where it will be clamped with an Adel clamp (where my hand is, there's already a nutplate on the back side of the firewall for it)...
...and at the bottom, the tube (aluminum section down here eventually) will S-turn through the engine mount and aim at the exhaust to burn off whatever blows out.
I discovered that bending 5/8" 2024T3 tubing isn't quite as simple as the old "bend it over the knee" trick. I kinked it pretty good. I need to get a 5/8" tubing bender...
